Comments

Document Feedback - Review and Comment

Step 1 of 4: Comment on Document

How to make a comment?

1. Use this Protected Document to open a comment box for your chosen Section, Part, Heading or clause.

2. Type your feedback into the comments box and then click "save comment" button located in the lower-right of the comment box.

3. Do not open more than one comment box at the same time.

4. When you have finished making comments proceed to the next stage by clicking on the "Continue to Step 2" button at the very bottom of this page.

 

Important Information

During the comment process you are connected to a database. Like internet banking, the session that connects you to the database may time-out due to inactivity. If you do not have JavaScript running you will recieve a message to advise you of the length of time before the time-out. If you have JavaScript enabled, the time-out is lengthy and should not cause difficulty, however you should note the following tips to avoid losing your comments or corrupting your entries:

  1. DO NOT jump between web pages/applications while logging comments.

  2. DO NOT log comments for more than one document at a time. Complete and submit all comments for one document before commenting on another.

  3. DO NOT leave your submission half way through. If you need to take a break, submit your current set of comments. The system will email you a copy of your comments so you can identify where you were up to and add to them later.

  4. DO NOT exit from the interface until you have completed all three stages of the submission process.

 

University Fleet Vehicle Use Procedure

Section 1 - Introduction

(1) The University of Newcastle (University) is committed to ensuring that owned and leased fleet vehicles are used in an efficient, cost effective and safe manner; and in a way that supports University business.

Top of Page

Section 2 - Scope

(2) This procedure applies to:

  1. all fleet vehicles, owned or leased by the University; and
  2. staff, students and approved guests.

(3) This procedure does not apply to motor vehicles leased by staff as part of salary packaging arrangements.

Top of Page

Section 3 - Audience

(4) This procedure should be read and understood by:

  1. vehicle custodians;
  2. drivers of University fleet vehicles; and
  3. business unit heads.

(5) This procedure should be read in conjunction with:

  1. the University Health and Safety Management System documents, including KRA procedure 2.5 Travelling on University business;
  2. Student Code of Conduct / Staff Code of Conduct;
  3. Travel Procedure; and
  4. any operational guidelines set down by the business unit responsible for the vehicle.
Top of Page

Section 4 - Definitions

(6) In the context of this document:

  1. “approved guest” means a person who is not a University staff member or student and who is approved by the business unit head to travel in a University fleet vehicle;
  2. “department vehicle” means a University fleet vehicle assigned to a college or department;
  3. “garaged at home” includes but is not limited to off-street parking, private garaging, and on-street parking; 
  4. “pool vehicle” means a University fleet vehicle that is made available for use by staff;
  5. “relevant business unit head” means the head of the University business unit that is responsible for the University fleet vehicle;
  6. “vehicle custodian” means a staff member who is responsible for the day to day management of the fleet vehicle/s; and
  7. “University fleet vehicles” means vehicles, either owned or leased by the University, that are used for official University business.
Top of Page

Section 5 - Conditions of Use

Eligible Drivers

(7) Each fleet vehicle is classified as a pool vehicle or a department vehicle, and as such, cannot be assigned to the exclusive use of one person.

(8) Vehicles can be driven by students or approved guests (for University business purposes) subject to prior written approval from the relevant business unit head.

(9) Note, the University will permit international drivers licence holders to drive a University fleet vehicle, subject to written approval from the relevant business unit head, providing this is in accordance with the jurisdictional requirements of the state in which any driving will occur.

Driver Responsibilities

(10) Before driving the vehicle, drivers must:

  1. conduct a visual inspection of the vehicle prior to travel and report any damage to the vehicle custodian prior to the vehicle use;
  2. familiarise themselves with the processes outlined in the Driver Information Kit (located in the vehicle), specifically in relation to roadside assistance and accident management; and
  3. when towing trailers / equipment, ensure that:
    1. the vehicle to be towed is in good condition and meets requirements for restraining loads;
    2. the vehicle to be towed is appropriately insured; and
    3. the manufacturer’s towing limits are adhered to at all times.

(11) When driving University fleet vehicles, drivers must:

  1. comply with all relevant legislation, including jurisdictional licencing requirements for the state in which any driving will occur;
  2. comply with all relevant University policies;
  3. drive in a safe manner;
  4. hold a current and valid driver’s licence, excluding learners permits, and drive to any conditions of their licence; 
  5. action any accidents or damage to the vehicle, regardless of whether any injury was sustained, in accordance with the Accident Management process outlined in the Driver Information Kit contained in the vehicle. In addition, notification should be provided to the vehicle custodian as soon as reasonably practical; and
  6. not use fleet vehicles for private purposes.

(12) Drivers must return vehicles with no less than half a tank of fuel. Drivers must re-fuel using the provided fuel card in the vehicle. Where a fuel card is not provided, or not available for use, a company credit card may be used. Similarly, electric vehicles must be returned fully charged or placed on charge when returned. 

(13) The transport of passengers who have no relationship with the University (e.g. family, friends, hitch-hikers etc) in University vehicles, except for approved guests, is prohibited.

(14) Smoking in University fleet vehicles is strictly prohibited.

(15) University fleet vehicles may only be garaged at home where it would not be practical to do otherwise. (For example, an early offsite business meeting the following day; or a late finish that does not practically allow for the vehicle to be returned to campus). When garaged at home the vehicle is not to be used for any private purposes while in the driver’s possession overnight. The relevant business unit head responsible for the vehicle must provide approval for the fleet vehicle to be garaged at home.

(16) Except for assistance / support dogs, pets or other animals are not permitted in University vehicles unless required for research or business needs. Accordingly, where animals are required to be transported, this must only occur in an air-conditioned vehicle, and with the animal appropriately restrained according to state road rules and any relevant legislation.

(17) Drivers of University fleet vehicles must take responsibility for any traffic or parking fines that are imposed on the University fleet vehicle whilst the vehicle is in the driver’s possession.

(18) Drivers must:

  1. return fleet vehicle keys to the vehicle custodian or nominated person upon cessation of use;
  2. ensure the cleanliness of the fleet vehicle is commensurate with the condition in which it was received at the beginning of its use; and
  3. park returned fleet vehicles to their designated parking bay on campus.
Top of Page

Section 6 - Vehicle Maintenance Standards

(19) Vehicles must be:

  1. serviced in accordance with the manufacturer’s specifications and by an authorised service provider; and
  2. maintained in a safe and roadworthy condition.

(20) Any damages or faults must be repaired appropriately and in a timely manner. For leased vehicles, repairs should be done in accordance with the leasing providers fair, wear & tear guide prior to the end of the lease.

(21) All standard passenger vehicles will be replaced after a period of 5 years. Heavy duty and commercial vehicles will be assessed for replacement on a case by case basis.

Top of Page

Section 7 - Reporting Accidents or Incidents

(22) Motor vehicle accidents or incidents in a University fleet vehicle must be acted on immediately, as per the Accident Management Process outlined in the Driver Information Kit, contained in the vehicle.

Top of Page

Section 8 - Hygiene Protocol

(23) The following cleaning protocols must be upheld:

  1. all vehicles must be professionally cleaned on a regular basis, as deemed reasonable, to reduce work health and safety risks and to uphold vehicle maintenance;
  2. all vehicles must be kept free of loose items and rubbish; and
  3. drivers are to be provided with appropriate sanitisation resources to ensure that the vehicle is cleaned before and after each use. 
Top of Page

Section 9 - Custodians

(24) Vehicle custodians are responsible for:

  1. the day to day management of the vehicle/s to which they are assigned;
  2. ensuring that all drivers are:
    1. aware of the responsibilities outlined in this procedure;
    2. familiar with the individual operating requirements of the vehicle (e.g. fuel type, features etc);
  3. capturing the drivers licence details of each driver, in accordance with relevant privacy statutory obligations, in the event that an infringement notice needs to be assigned to the driver;
  4. ensuring that vehicle keys and fuel cards are stored in a secure location, with controlled access;
  5. ensuring logbook records are kept up to date and are appropriately filed for record keeping;
  6. receiving notifications of any servicing/inspection requirements and actioning them in line with the manufacturers recommendation;
  7. ensuring that the vehicle is kept clean, in a safe and roadworthy condition, and that any repairs are completed within a timely manner;
  8. regularly conducting vehicle safety inspections to ensure that any damage is repaired appropriately;
  9. familiarising themselves with the processes outlined in the Driver Information Kit in relation to arranging repairs, roadside assistance, and accident management; and ensuring that a copy of the Driver Information Kit is kept in the vehicle at all times in the event that a driver needs to access it; 
  10. ensuring the hygiene protocols are appropriately implemented, as per Section 8; and
  11. ensuring pink slips are obtained in a timely manner.