Comments

Document Feedback - Review and Comment

Step 1 of 4: Comment on Document

How to make a comment?

1. Use this Protected Document to open a comment box for your chosen Section, Part, Heading or clause.

2. Type your feedback into the comments box and then click "save comment" button located in the lower-right of the comment box.

3. Do not open more than one comment box at the same time.

4. When you have finished making comments proceed to the next stage by clicking on the "Continue to Step 2" button at the very bottom of this page.

 

Important Information

During the comment process you are connected to a database. Like internet banking, the session that connects you to the database may time-out due to inactivity. If you do not have JavaScript running you will recieve a message to advise you of the length of time before the time-out. If you have JavaScript enabled, the time-out is lengthy and should not cause difficulty, however you should note the following tips to avoid losing your comments or corrupting your entries:

  1. DO NOT jump between web pages/applications while logging comments.

  2. DO NOT log comments for more than one document at a time. Complete and submit all comments for one document before commenting on another.

  3. DO NOT leave your submission half way through. If you need to take a break, submit your current set of comments. The system will email you a copy of your comments so you can identify where you were up to and add to them later.

  4. DO NOT exit from the interface until you have completed all three stages of the submission process.

 

Weighted Average Mark (WAM) Calculation Guideline

Section 1 - Introduction

(1) A weighted average mark (WAM) is the average mark achieved across all completed units in a Program, or a defined set of completed units, including fail grades, weighted according to the unit value and academic level of the particular course.

Top of Page

Section 2 - Intent

(2) This guideline has been developed to assist staff and students to calculate WAM.

Top of Page

Section 3 - Instructions

(3) The WAM is calculated as:

  1. A cumulative WAM, calculated over all units undertaken within the Program; or
  2. A WAM calculated over a specified number of units or all units at or above a specified level; 
    1. for calculation of Honours in accordance with the Bachelor Honours Policy, the weighted average mark calculated over all 2000, 3000, 4000, 5000 and 6000 level courses;  or 
  3. A WAM calculated over an approved major; or
  4. An annual WAM is the weighted average mark of the results of courses taken in a particular calendar year. 

(4) The WAM can be expressed mathematically as:

WAM = Σ (M V W)/Σ (V W)
Where:
M = the mark as defined below;
V = the unit value of the course concerned; and
W = the weighting of the course concerned as set out below.

(5) The value of “M” is defined as followed:

  1. Where the result in a course is given in the range 50 to 100 inclusive, “M” is equal to that percentage mark;
  2. Where the result in a course is a failing grade, in the range 45 to 49 inclusive, “M” is equal to that percentage mark;
  3. Where the result in a course is a failing grade, in the range of 0 to 44, “M” is equal to a mark of 44;
  4. Where the student has passed the course but the result is not provided as a percentage mark and the student receives a UP (ungraded pass) the mark demoted as “M” will be deemed to be as per Clause 9.

Table 1

Grade Percentage Mark M
UP* Not provided 58* (refer to Clause 9)
FF 45-49 Equal to the percentage mark
FF 0-44 44

(6) The first number of a course code indicates the level at which the Course is offered regardless of the year of study in which it is undertaken and, also indicates the weighting of the course in terms of the Weighted Average Mark (WAM) calculation. For example, if the course INFO1010 is undertaken in the fourth year of study, the course is still considered to be a 1000 level course and the weighting will be 1.

Table 2 Course Weightings (cumulative WAM)

Course Level Weighting
1000 1
2000 2
3000 3
4000, 5000 and 6000 4

(7) The WAM for Bachelor Honours is calculated on all courses above the 1000 level and weighted as per table 3:

Table 3 Course Weighting (Bachelor Honours)

Course Level Weighting
2000 2
3000 3
4000, 5000 and 6000 4

(8) The determination of units to be included in the calculation of the WAM is as follows:

  1. Where all units have been completed at the University of Newcastle and within the same Program, all units will be included in the WAM calculation;
  2. Where all units have been completed at the University of Newcastle but across different programs, all units that have contributed to the relevant Program being awarded will be included in the WAM calculation (including credit);
  3. Where a student has received credit from an external institution (including cross-institutional study) only those units completed at the University of Newcastle will be included in the WAM calculation;
  4. Where a student has completed more than the maximum units, only the approved units will be counted towards the WAM calculation. For example in a 240 unit Program will use only 240 units of approved courses where the student has received a pass (or greater) plus all fail grades. Students who over-enrol (i.e. Extraneous enrolment in units additional to the overall program value) the earliest completed courses only are counted;
  5. Courses completed extraneously cannot be counted within the WAM calculation. Students who have successfully completed a course will not be permitted to undertake the same course again (see definition for Extraneous enrolment in a course);
  6. Where, through an administrative error, a student has passed the same course twice, the grade of the first completion, not the highest mark, will be utilised in the WAM calculation; and
  7. Where a student is studying a combined program, only those units which have contributed to the completion of each single program will be included in the WAM calculation for each of the program or the WAM may be calculated for the overall unit value for the combined program, subject to the conditions outlined above.

(9) *Ungraded pass (UP) Grades are not included in the calculation of a WAM except:

  1. where the inclusion of the ungraded pass grade in the calculation will advantage the student, ie when the student has a WAM of less than 58. In this instance the WAM is recalculated including the value of the ungraded pass grades; or
  2. when more than 50% of the grades presented are ungraded pass grades. In this instance, the WAM would be calculated with the ungraded pass grades included in the calculation. 

(10) Multi-term sequence courses

  1. Upon completion of Part A of a multi-term sequence course  students will be awarded an NA grade, NA grades are not included in WAM calculations.
  2. Upon completion of Part B of a multi-term sequence course  students will be awarded a percentage mark and grade, weighted according to the unit value of Part A and B, this mark will be included in the WAM calculation.

(11) The following will be taken into account when calculating the WAM: 

  1. Students re-enrolling after leave of absence will retain their previous WAM as the basis of future calculations; 
  2. If grades of ‘Incomplete” (I) or Special Consideration (S) are awarded to a students, the WAM will remain uncalculated until the final marks are awarded. 
Top of Page

Section 4 - Roles and Responsibilities

(12) University  staff to calculate WAM in accordance with these Guidelines.

(13) Students can calculate their WAM using these Guidelines. 

(14) Students must enrol in courses  which comply with their program requirements.